Revised Electronics Enclosure
Design work continues. Focused on wiring and electronics enclosure.
Finally able to start back into the CNC project. Converting to PETG for final prototype parts.
Hot cars and PLA dont mix.
Work towards a finished prototype continues... Lessons in Fusion360 design also keep coming. I have decided that adding the proper nuts and screws will be a last step due to issues Fusion has
A few months ago I ordered Prusament PETG off of Amazon. I was curious about how well it would work considering Prusa seem to have their act together regarding all things 3D printing.
Testing the Spindle Motor and PSU I got. Good to see they are not duds (so far), but I will likely have to buy another three phase motor that isnt limited to the
Almost done designing the frame. Started adding in nuts and screws of the correct size so I can make a BOM when all is said and done. I'm probably going to re-work the
Started prototyping with PLA. I did end up removing the raised portion of the base. The reason I ended up doing this was due to accessibility to components, dust accumulation, and bed leveling.
Figured it was about time to share a little progress on the remix I have been working on. A huge shout-out to Nikodem Bartnik for the base Dremel CNC design. Unfortunately, this will